Show All Answers
Inspection requests and results are available by contacting the building department at 954.753.5447.
The Florida Building Code mandates that all components in the Building Envelope must be products which are “approved” for use as shown on your plans. This Schedule is to be completed for all new construction, including remodeling, in which windows, doors, skylights, vents, and other products are to be incorporated into the exterior walls and/or roof of a building. Each product must be an “approved” product as outlined by the Florida Building Code. All products must also be approved for use by your Architect or Engineer of Record, and the Tested Pressure of each product (size-specific) must meet or exceed the Design Pressure specified by the A/E of Record. This addendum to your permit plans, consisting of this Schedule and all referenced product approval documentation, must be submitted early in the construction process, usually before the Tie Beam inspection can be scheduled, and must be approved by our plans examiner prior to the installation of the referenced products.
New pools, and pools which had not received a final inspection until October 1, 2000, are governed by the Pool Safety Act, which has been fine-tuned and is now incorporated within the Florida Building Code.
The Pool Safety Act requirements are as stringent as they are complex. The basic requirement is that any new pool must be built with protection by means of fence, screen enclosure, alarms, baby barrier, or a combination of these components which serves to provide a barrier to entrance to the pool from all directions, for 360 degrees around the pool.
424.2.17 Residential swimming barrier requirement, a part of the Florida Building Code, may be accessed online, then selecting Florida Building Code 2007, the Building volume, Chapter 4, Section 424.2.17.
Existing Pools Completed After May 22, 1996 But Before September 30, 2000: On May 22, 1996, the City passed a fence ordinance requiring a minimum 4’-high fence, with self-closing, self-locking gate(s), or a screen enclosure, around any pool which had not yet been completed, or for which the final inspection had not yet been approved. However, there is an exception for a property located on a waterway: no fence is required along the plot line(s) bounded by water. And, exempted from these enclosure requirements are pools located in A-1, AE-1, and AE-2 zoning districts, such as Tall Pines, Pinetree Estates, and the Ranches.
City Ordinance 22-88(6) may be found among the ordinances posted at Municode, or by following the link on the City website.
Existing Pools Completed Prior To May 22, 1996: There were no code-mandated requirements for a new pool completed prior to May 22, 1996 to have a fence or screen enclosure.
Yes. All construction work which is required to be permitted is the responsibility of the current property owner. Please contact the Building Division at 954.753.5447 to discuss procedures specific to your situation for obtaining a permit and bringing the work into compliance.
Note: a permit, where required, must be applied for and acquired before any such work may commence.